Common problems and solutions of vibrating screen

Common problems and solutions of vibrating screen
Fault 1, the vibration motor is running normally
Solution:
1, open the switch to confirm whether the power supply problem;
2, to confirm whether the cable is intact, with or without broken wire - new cable;
3, check the cable length is long enough, the interface with no contact bad - new cable;
4, see the vibration motor coil has not burned - new motor;
5, see the vibration motor in the amount of oil - to keep the motor running.
Failure two, vibrating screen issued an abnormal sound

Solution:
1, the installation of vibrating sieve foundation uneven - flat foundation;
2, see whether the spring off - new spring;
3, see whether the vibrating screen body collision with other objects - adjust the space to avoid collision;
4, see the discharge port is collision with other objects - adjust the space to avoid collision;
5, whether the motor screws are loose or removed - tighten or replace.
Failure three, the material can not be automatically discharged
Solution:
1, see whether the motor line is reversed lead to the wrong direction of operation of the motor - in the correct order to connect the line;
2, see whether the eccentric shaft bearing wear or rupture - replace the new bearings.
Failure four, screen easy to break
Solution:
1, whether the screen tighten - re-replace the screen or adjust the tension of the screen;
2, to see whether the material cutting speed is too fast and direct impact on the net - to use the buffer.
Failure five, easy to break the screen frame
Solution: As the mine shaker treatment of the material is too large, heavy, the impact of the screen frame is also large, you can install the polyurethane frame sieve to ease the impact force.